How to make a spiral in solidworks ?

Best answer:

1. . In a part, do one of the following: Open a sketch and sketch a circle. Select a sketch that contains a circle.
2. . Click Helix and Spiral (Curves toolbar) or Insert > Curve > Helix/Spiral .
3. . Set values in the Helix/Spiral PropertyManager.
4. . Click .

How do you make a conical helix in SolidWorks?

FAQ

How do you make a 2D spiral in Solidworks?

1. Specify a point (P2) to define the base radius. This point defines the start point.
2. Or follow these steps: Type a value to define the base radius. Set the start angle.
3. Set the Diameter: Specify the base diameter. Specify the start point or type the start angle value.

How do you make a rectangular spiral in Solidworks?
How do I make a spiral in SolidWorks? For this first draw a circle like this. Then go to features tab and click the helix and spiral feature from the curves drop down menu.

How do you make a conical spring?

1. In a conical coil spring with a fixed pitch angle, R and n’ (= θ / 2π) are associated with the following formula.
2. The deflection before the coils are compressed to the ground is calculated by integrating dδ = (2πφ / ν) R2dR, where ds is eliminated from the two formulas dδ = Rφds and dR = (ν / 2πR) ds, from R1 up to R2.

WHAT IS curve driven pattern in Solidworks?
The Curve Driven Pattern tool allows you to create patterns along a planar or 3D curve. To define the pattern, you can use any sketch segment, or the edge of a face (solid or surface), that lies along the plane. You can base your pattern on an open curve, or on a closed curve, such as a circle.

What does the twist along path option while sweeping do?
Under sweep Options, when you select Follow path as the Orientation/twist type, you can select parameters to stabilize the profiles when small and uneven curvature fluctuations along the path cause the profiles to misalign.